Re: SHUB3 install - poor speed
Spoke too soon. Back down to 10meg d/l despite good SNR. When I power up the shub can't get a net connection and runs that online diagnostic from an IP address - which doesn't cure anything. If I then leave it for about a minute or so, I get connected albeit at a very reduced level to what I should have - 10 instead of 100meg d/l.
Intrestingly, my ping is good and u/l is a consistent 5meg
Any thoughts?
Cheers
---------- Post added at 13:06 ---------- Previous post was at 11:22 ----------
Hmm... I've observed a somewhat curious behaviour.
I switch off all my kit when not in use. Completely power down.
If I then start it up, I see the stuff above - no connection, after a while connects with pants speed etc. However, once connected, if I then reboot just the PC, I get a great 100mbits back on d/l.
Does this then imply that the SHUB should be left on "standby" at all times?
I haven't yet tried modem mode - would this help?
|