Cable Forum - View Single Post

18-02-2006, 16:32

Hi Chuffy welcome to TW,

WAN side should always be Automatic Configuration - DHCP with TW CM.
You do not need to enter a hostname or domain.

When you have set it up power off both the cable modem and the router.

Power on the cable modem, wait 60 secs, plug in the ethernet cable between the cable modem and the router making sure the USB cable is completely disconnected. Then power up the router. All settings should then be requested from the UBR by the router.

Lan side may be a little more of a challenge. The instruction manual should give you a few good tips.

Good luck.

18-02-2006, 16:32	#2
TW_BUS_DATA_TECH Guest Posts: n/a	Re: Telewest Wireless settings Hi Chuffy welcome to TW, WAN side should always be Automatic Configuration - DHCP with TW CM. You do not need to enter a hostname or domain. When you have set it up power off both the cable modem and the router. Power on the cable modem, wait 60 secs, plug in the ethernet cable between the cable modem and the router making sure the USB cable is completely disconnected. Then power up the router. All settings should then be requested from the UBR by the router. Lan side may be a little more of a challenge. The instruction manual should give you a few good tips. Good luck.